I’ve been getting some great prints on my OctiZ, but it seems like every now and then when I run a larger print it won’t center correctly.
It homes correctly, in Cura the print is centered, and in OctiPrint the output shows that it should be dead on the center. It’s almost like once it zeros out it then goes to the center of the platform decides that’s the new 0,0 and goes from there.
I did increase the bed size to 190mm a while back on both OctiPrint and Cura but I’m not sure if that has anything to do with it.
Is this something that anyone else has had an issue with?