Zimboard for octprint

#21

ok got it
i turned it on and got this
�HELLO! BOOT0 is starting!
boot0 version : 2.0.0�
read dram para.
dram driver version: 1.15
dram size =1024MB
0xffffffff
super_standby_flag = 0
Succeed in opening nand flash.
block from 2 to 6
deal block 2
Succeed in reading Boot1 file head.
The size of Boot1 is 0x00068000.
The file stored in 0x00000000 of block 2 is perfect.
Check is correct.
Ready to disable icache.
Succeed in loading Boot1.
Jump to Boot1.
[ 0.148] boot1 version : 2.0.0
[ 0.148] script installed early ok
[ 0.149] pmu type = 3
[ 0.253] bat vol = 0 mv
[ 0.266] axi:ahb:apb=4:2:2
[ 0.266] set dcdc2=1400mv, clock=912M successed
[ 0.269] key
[ 0.281] no key found
[ 0.281] flash init start
[ 0.281] NB1 : enter NFB_Init

[ 0.284] NB1 : enter phy init

[ 0.287] [NAND] nand driver(b) version: 0x0x00000002, 0x0x00000012, data: 0x20130627

[ 0.295] get the good blk ratio from hwscan : 944

[ 0.300] NB1 : nand phy init ok

[ 0.342] get mbr error

[ 0.342] NB1 : init ok

[ 0.342] flash init finish
[ 0.346] mbr magic is not correct
[ 0.348] fs init fail
[ 0.351] fs init fail, jump to fe

#23

ok i made a bootable sd and turned on and this is what i got
any suggestions?
sorry was too big to upload
basically it goes through boot then repeats the same thing over and over
'https://docs.google.com/document/d/1zUrnnW88-X7-T_oLOq2-jAG-GArs1jYoaWvnupyxnxI/edit?usp=sharing

#24

I haven’t been on here in a while. Just been super busy with work. @Dante_Totino did you get your Zim flashed properly yet?

#25

i actually just decided to switch to a rpi thank you though

1 Like
#26

It’s cheap and well supported :slight_smile: Good choice!

#27

i deleted the original firmware that was on the sd card the aim came with what do i do :frowning:

#28
  1. Keep calm, take a deep breath and relax.
  2. Download @Jaesin ´s rooted Zeepro Firmware HERE if you´d like to stay as genuine as possible OR
  3. Download @waffles “Octoprintified” software HERE if you want to have maximum control
    No matter which you choose, read the topics as there are many hints for proper installation OR
  4. Or buy a Raspberry Pi and download octoprint for Raspberry Pi HERE. You´ll have to tinker around a bit with the cover of the USB Port at the back of your ZIM, but I already removed two of them without problems.

The SD-Card in the cubieboard contains no vital data, but it is necessary to have a card inserted for the cubie to run, as it saves your uploaded gcodes and some other files there. It should work if you insert some FAT32 formatted SD-Card.

1 Like