Thought I would start to write out a list of the webpages that Zim uses. In all the links below replace zimip with the ip address of your zim. I hope it’s obvious that some controls on these pages could cause damage to your printer if not used properly.
http://zimip/sliceupload/slicestatus - Slicer status page
http://zimip/sliceupload/slice?callback - Print page (I’ve used this plenty after cancelling a print in order to reprint something)
http://zimip/gcode/slice/render - Page that shows the generated g-code and 2D rendering of layers
http://zimip/printdetail/timelapse - After a print, this opens the page with the timelapse video and sharing
http://zimip/cartridge/left - Left cartridge RFID update page
http://zimip/cartridge/right - Right cartridge RFID update page
http://zimip/extrusion_control - Extrusion control settings including ability to send gcode commands
http://zimip/zeepronterface - Pronterface page, similar to extrusion_control but with position controls and ability to send multiline gcode commands
http://zimip/test_log/printlog - Log of gcode commands during the most recent print
http://zimip/test_endstop - Opens a page with endstop indicators
http://zimip/language - Change language between english and french
If there are other pages I missed post them below and I’ll add them to this list.