Slic3r profiles

#1

hey
i know that some people have posted their setting for slic3r but i have tried them all with still very bad results
will some other people who have had success with slic3r or cura please post their profile files or settings
thank you much appreciated

#2

when you set up your octoprint, did you also install Jpod’s updated firmware on your Zim? I found that doing that made a HUGE difference in my prints. Also do you have any pics of what your prints look like right now?

#3

Three troubleshooting pictorial resources for you that were a big help to me:

  1. https://www.simplify3d.com/support/print-quality-troubleshooting/

  2. http://reprap.org/wiki/Print_Troubleshooting_Pictorial_Guide

  3. http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide

#4

thank you i will do that now then try a print and post a pic if its bad