Preview loops - help please

#1

Hi,

I’ve been keeping an eye on these forums wondering when I would have to take the plunge and dig into my zim. So far it’s still working and amazon has had some ridiculously good deals on filament.

Today I’ve had an issue where when I load a model and get to the preview stage, when I click print it circles back to the preview page on an endless loop.

Any thoughts or suggestions?

Thanks!

#2

Mine did that and I ended up just removing the control board and hooking it up to the computer with a USB cable.

Hope you have better luck.

#3

I also had this problem when my ZIM still ran under the standard software. Easiest way was to re-flash the latest software. Takes only 10 minutes and works 99.99%

#4

Thanks for the help! I got that working again - just a reset of the Zim was needed.